C-2299~VRC

Overview

The C-2299/VRC is used between receiver-transmitters of Radio Sets AN/VRC-49 and AN/VRC- 45 to provide automatic retransmission of signals between radio sets that are too far apart to communicate directly with each other.

Receiver-Transmitter No. 1 and terminal radio No. 2 operate on one frequency (F1), and receiver-transmitter No. 2 and terminal radio No. 4 operate on another frequency (F2). For retransmission operation, the radios in the system must operate on squelch mode.

When the C-2299/VRC RETRANS switch is set to ON, the retransmission of signals and keying control are automatically passed through the C-2299/VRC to the retransmission site receiver-transmitters. When the C-2299/VRC RE- TRANS switch is set to OFF, the user has control of the two receiver-transmitters from the audio accessories connected to the C-2299/VRC. In position 1 of RAD TRANS switch, receiver- transmitter No. 1 is controlled; in position 2 of RAD TRANS switch, receiver-transmitter No. 2 is controlled.

Audio accessories can be connected to the C-2299/VRC to enable the radio user to communicate through the retransmission site receiver- transmitters with the terminal radios. When the C-2299/VRC RETRANS switch is set to ON, the radio user cannot communicate with the terminal radios, but can hear the transmission occurring between the terminal radios.

However, when the C-2299/VRC is connected to the AM-1780/VRC of the radio-intercom system the receiving circuits of the receiver- transmitters No. 1 and 2 are not available at the C-2299/VRC. Thus, radio communication is conducted from the crew member control boxes. Also, for the retransmission operation, the INSTALLATION switch of the AM-1780/VRC is set to the RETRANS position. Under these conditions, the retransmission signals are available on the ALL position of the crew member control boxes.

Use as a remote keying station for VRC-12 series radios

The C-2299 can be used as a remote keying station for the VRC-12 series radios. When hooked to the MT-1029, the C-2299 allows remote use of the microphone and speaker for up to two radios. A typical example is for the C-2299 to be installed in the front cab of a vehicle while the radios remain i the rear, or under the seat.

Use as an auxiliary interface for microphones and headsets

The C-2299 is the only way to properly use a microphone directly on the VIC-1.

Images

• 
• 

Example Hookup

Schematics

• 
• 

Additional Files

TM 11-5820-401-35-1

DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS

CONTROL, FREQUENCY SELECTOR C-2742/VRC

CONTROL, RADIO SET C-2299/VRC

April 1973