Difference between revisions of "TA-312~PT"

From RadioNerds
Jump to navigation Jump to search
Line 122: Line 122:
 
::Users Guide
 
::Users Guide
 
::30 November 1976
 
::30 November 1976
 +
 +
 +
;{{pdf|Subcourse_MM0411-8.pdf|Subcourse MM0411, Edition 8}}
 +
:Army Correspondence Course Program
 +
::Troubleshooting and Final Testing of the TA-312/PT Telephone (MOS 29N)
 +
::30 September 1988
  
  

Revision as of 12:00, 13 March 2015

TA-312-6.png

The TA-312/PT and the TA-43/PT are two-wire, battery-operated field telephones. They may be used in a point-to-point wire system or in any two-wire ring-down subscriber position of a telephone communications system. The Handset H-60 contains a push-to-talk switch which connects power for talking. The TA-312/PT has a built-in Receptacle Connector U-79/U for use with a headset and an associated EXT-INT switch; the TA-43/PT does not. The TA-43/PT was replaced by the TA-312/PT. The TA-955/PT dual tone multi frequency (DTMF) adapter allows push button operational interface with automatic analog switches and regular civilian type phone systems.


Differences Between TA-312 and TA-312A

TA-312 vs TA-312A.png


  1. Case on the "A" is made from a composite material, and the TA-312 is metallic
  2. The handset retaining spring on the "A" is a locking mechanism, you need to push the handset upward to release it. The regular TA-312 has a simple spring.
  3. The "A" version has recessed areas around the battery lock and the EXT-INT switch.
  4. The "A" version has screws to retain the hinges
  5. The ID plates on the "A" is horizontal, where the standard version is vertical.


Technical Characteristics

Range
Wet
Approximately 22.5km(14mi) on WD-1/TT (36 dB working limit)
Dry
Approximately 36.4 km (22 mi) on WD-1/TT (36 dB working limit)


Type of Operation
Common Battery
Voice transmission and signaling power supplied by switchboard
Local Battery
Voice transmission power supplied by two BA-30s, signaling power supplied by a hand-crank generator
Common-Battery Signaling
Signaling power supplied by switchboard, voice transmission provided by two BA-30s
Signaling (Outgoing)
Hand generated, 90 to 100VAC, 20Hz
Signaling (Incoming)
Audible tone, adjustable volume


Controls and Indicators

Hook Switch
Connects H-60PT to line during operation. Switch is operated when H-60/PT is removed from retaining cradle and is open when H-60PT is in retaining cradle.
Selector Switch
Connects internal circuits of TA-312/PT for particular type of service to be used:
Position
CB
Common battery operation, power comes from the switchboard
LB
Local battery operation, power is from the local installed batteries
CBS
Common battery signaling (local battery for voice), power from switch board, but the installed batteries are used for voice. this is useful if the sound quality is low due to long distance from the switchboard.
EXT-INT Switch
Permits selection of H-144(*)/U in place of H-60/PT:
EXT
Selects H-144(*)/U (H-60/PT inoperative).
INT
Selects H-60/PT (H-144(*)/U inoperative).
LOW-LOUD
Adjusts BZ-23/PT (ringer) Volume
HandCrank (part of G-4WPT)
When turned, operates G-42A/PT for signaling in LB operation.


Operation

  1. Connect WD-1/TT wire or other to the terminal posts of each phone. It doesnt matter which post, there is no polarity/
  2. Install 2 "D" size batteries
  3. Set the Selector switch to LB (Local Battery) mode
  4. Turn side crank several times quickly to ring the other phone.
  5. lift handset to listen for an answer. In the TA-312 simply lift up on the handset, in the TA-312A, you need to push the handset up to release it from the cradle.
  6. press button on handset to talk. you should hear a sidetone (hear yourself in the speaker) when you talk.
  7. release handset button to allow the other person to talk.
  8. when the call is completed, hang up the phone. You should keep the phone in the cradle when not in use, this will keep the batteries from draining. If the handset is not fully seated anyone on the other side can still hear your conversations via the sound powered function.


Emergency Sound Power Operation

If no battery supply is available, it is possible to transmit for approximately 4 miles by using the receiver (ear speaker, not the microphone) element as a sound-powered transmitter element.

  1. Signal by turning the handcrank rapidly a few turns
  2. Speak directly into the receiver element, then listen while the distant party is transmitting.


Other Images


Parts Suppliers

http://www.signalcenter.com
Excellent Service and Lots of new parts for the TA-312 (2013)

Related Files

Adobe PDF icon.png TM 11-5805-201-12

Organizational Maintenance Manual
Telephone Set
TA-312/PT (5805-00-543-0012)
1 August 1990


Adobe PDF icon.png TM 11-5805-201-23P

Operator’s and Direct Support Maintenance
Repair Parts and Special Tools List
Telephone Sets
TA-312/PT (5805-00-543-0012)
TA-312A/PT (5805-01-217-7310)
1 January 1987


Adobe PDF icon.png TM 11-5805-201-35

DIRECT SUPPORT, GENERAL SUPPORT, AND DEPOT MAINTENANCE MANUAL INCLUDING REPAIR PARTS AND SPECIAL TOOLS LISTS
TELEPHONE SET
TA-312/PT (5805-00-543-0012)
September 1967


Adobe PDF icon.png TC 24-3

Radio Wire Integration
Installation and Operation Tips
Users Guide
30 November 1976


Adobe PDF icon.png Subcourse MM0411, Edition 8

Army Correspondence Course Program
Troubleshooting and Final Testing of the TA-312/PT Telephone (MOS 29N)
30 September 1988


Adobe PDF icon.png PM Magazine June 2001 TA-312

Adobe PDF icon.png PM Magazine April 2010 TA-312